AT90PWM2 datasheet(287/361 Pages) ATMEL

tên linh kiện	AT90PWM2

Giải thích chi tiết về linh kiện	8-bit Microcontroller with 8K Bytes In-System Programmable Flash

PDF	361 Pages

Scroll/Zoom	100%

nhà sản xuất	ATMEL [ATMEL Corporation]

Trang chủ	http://www.atmel.com

Logo

287 / 361 page

287

4317J–AVR–08/10

AT90PWM2/3/2B/3B

Give WR a negative pulse. This starts programming of the entire page of data. RDY/BSY

goes low.

Wait until RDY/BSY goes high (See Figure 25-3 for signal waveforms).

I. Repeat B through H until the entire Flash is programmed or until all data has been

programmed.

J. End Page Programming

1. Set XA1, XA0 to “10”. This enables command loading.

Set DATA to “0000 0000”. This is the command for No Operation.

Give XTAL1 a positive pulse. This loads the command, and the internal write signals are

reset.

Figure 25-2. Addressing the Flash Which is Organized in Pages

(1)

Note:

1. PCPAGE and PCWORD are listed in Table 25-11 on page 284.

Figure 25-3. Programming the Flash Waveforms(1)

Note:

1. “XX” is don’t care. The letters refer to the programming description above.

PROGRAM MEMORY

WORD ADDRESS

WITHIN A PAGE

PAGE ADDRESS

WITHIN THE FLASH

INSTRUCTION WORD

PAGE

PCWORD[PAGEMSB:0]:

PAGEEND

PAGE

PCWORD

PCPAGE

PCMSB

PAGEMSB

PROGRAM

COUNTER

RDY/BSY

RESET +12V

PAGEL

BS2

0x10

ADDR. LOW

ADDR. HIGH

DATA

DATA LOW

DATA HIGH

ADDR. LOW

DATA LOW

DATA HIGH

XA1

XA0

BS1

XTAL1

AT90PWM2 bảng dữ liệu(PDF) 287 Page - ATMEL Corporation

AT90PWM2 bảng dữ liệu(HTML) 287 Page - ATMEL Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

bảng dữ liệu tải về

Link URL