PC312XDP512F0CFVR datasheet(309/1348 Pages) FREESCALE

309 / 1348 page

MC9S12XDP512 Data Sheet, Rev. 2.21

Freescale Semiconductor

309

Chapter 7

Enhanced Capture Timer (S12ECT16B8CV2)

7.1

Introduction

The HCS12 enhanced capture timer module has the features of the HCS12 standard timer module

enhanced by additional features in order to enlarge the ﬁeld of applications, in particular for automotive

ABS applications.

This design speciﬁcation describes the standard timer as well as the additional features.

The basic timer consists of a 16-bit, software-programmable counter driven by a prescaler. This timer can

be used for many purposes, including input waveform measurements while simultaneously generating an

output waveform. Pulse widths can vary from microseconds to many seconds.

A full access for the counter registers or the input capture/output compare registers will take place in one

clock cycle. Accessing high byte and low byte separately for all of these registers will not yield the same

result as accessing them in one word.

7.1.1

Features

•

16-bit buffer register for four input capture (IC) channels.

•

Four 8-bit pulse accumulators with 8-bit buffer registers associated with the four buffered IC

channels. Conﬁgurable also as two 16-bit pulse accumulators.

•

16-bit modulus down-counter with 8-bit prescaler.

•

Four user-selectable delay counters for input noise immunity increase.

7.1.2

Modes of Operation

•

Stop — Timer and modulus counter are off since clocks are stopped.

•

Freeze — Timer and modulus counter keep on running, unless the TSFRZ bit in the TSCR1 register

is set to one.

•

Wait — Counters keep on running, unless the TSWAI bit in the TSCR1 register is set to one.

•

Normal — Timer and modulus counter keep on running, unless the TEN bit in the TSCR1 register

or the MCEN bit in the MCCTL register are cleared.

PC312XDP512F0CFVR bảng dữ liệu(PDF) 309 Page - Freescale Semiconductor, Inc