ATmega16A datasheet(106/352 Pages) ATMEL

106 / 352 page

106

8154B–AVR–07/09

ATmega16A

the maximum resolution is 16-bit (ICR1 or OCR1A set to MAX). The PWM resolution in bits can

be calculated using the following equation:

In phase and frequency correct PWM mode the counter is incremented until the counter value

matches either the value in ICR1 (WGM13:0 = 8), or the value in OCR1A (WGM13:0 = 9). The

counter has then reached the TOP and changes the count direction. The TCNT1 value will be

equal to TOP for one timer clock cycle. The timing diagram for the phase correct and frequency

correct PWM mode is shown on Figure 16-9. The figure shows phase and frequency correct

PWM mode when OCR1A or ICR1 is used to define TOP. The TCNT1 value is in the timing dia-

gram shown as a histogram for illustrating the dual-slope operation. The diagram includes non-

inverted and inverted PWM outputs. The small horizontal line marks on the TCNT1 slopes repre-

sent compare matches between OCR1x and TCNT1. The OC1x Interrupt Flag will be set when a

compare match occurs.

Figure 16-9. Phase and Frequency Correct PWM Mode, Timing Diagram

The Timer/Counter Overflow Flag (TOV1) is set at the same timer clock cycle as the OCR1x

Registers are updated with the double buffer value (at BOTTOM). When either OCR1A or ICR1

is used for defining the TOP value, the OC1A or ICF1 Flag set when TCNT1 has reached TOP.

The Interrupt Flags can then be used to generate an interrupt each time the counter reaches the

TOP or BOTTOM value.

When changing the TOP value the program must ensure that the new TOP value is higher or

equal to the value of all of the Compare Registers. If the TOP value is lower than any of the

Compare Registers, a compare match will never occur between the TCNT1 and the OCR1x.

As Figure 16-9 shows the output generated is, in contrast to the phase correct mode, symmetri-

cal in all periods. Since the OCR1x Registers are updated at BOTTOM, the length of the rising

and the falling slopes will always be equal. This gives symmetrical output pulses and is therefore

frequency correct.

RPFCPWM

TOP 1

()

log

()

log

-----------------------------------

OCRnx / TOP Update

and

TOVn Interrupt Flag Set

(Interrupt on Bottom)

OCnA Interrupt Flag Set

or ICFn Interrupt Flag Set

(Interrupt on TOP)

TCNTn

Period

OCnx

(COMnx1:0 = 2)

(COMnx1:0 = 3)

ATmega16A bảng dữ liệu(PDF) 106 Page - ATMEL Corporation

ATmega16A bảng dữ liệu(HTML) 106 Page - ATMEL Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

bảng dữ liệu tải về

Link URL