| công cụ tìm kiếm bảng dữ liệu linh kiện điện tử |
|
ATtiny44 bảng dữ liệu(PDF) 159 Page - ATMEL Corporation |
|
|
|||||||||||||||||||||||||||||
ATtiny44 bảng dữ liệu(HTML) 159 Page - ATMEL Corporation |
|
159 / 236 page ![]() 159 8006H–AVR–10/09 ATtiny24/44/84 19. Memory Programming This section describes the different methods for programming ATtiny24/44/84 memories. 19.1 Program And Data Memory Lock Bits The ATtiny24/44/84 provides two lock bits which can be left unprogrammed (“1”) or can be pro- grammed (“0”) to obtain the additional security listed in Table 19-2. The lock bits can only be erased to “1” with the Chip Erase command. The device has no separate boot loader section. The SPM instruction is enabled for the whole Flash, if the SELFPROGEN fuse is programmed (“0”), otherwise it is disabled. Program memory can be read out via the debugWIRE interface when the DWEN fuse is pro- grammed, even if lock bits are set. Thus, when lock bit security is required, debugWIRE should always be disabled by clearing the DWEN fuse. Note: “1” means unprogrammed, “0” means programmed. Notes: 1. Program fuse bits before programming LB1 and LB2. 2. “1” means unprogrammed, “0” means programmed Lock bits can also be read by device firmware. See section “Reading Lock, Fuse and Signature Data from Software” on page 155. Table 19-1. Lock Bit Byte Lock Bit Bit No Description Default Value 7 – 1 (unprogrammed) 6 – 1 (unprogrammed) 5 – 1 (unprogrammed) 4 – 1 (unprogrammed) 3 – 1 (unprogrammed) 2 – 1 (unprogrammed) LB2 1 Lock bit 1 (unprogrammed) LB1 0 Lock bit 1 (unprogrammed) Table 19-2. Lock Bit Protection Modes. Memory Lock Bits (1) (2) Protection Type LB Mode LB2 LB1 11 1 No memory lock features enabled. 21 0 Further programming of the Flash and EEPROM is disabled in High-voltage and Serial Programming mode. The Fuse bits are locked in both Serial and High-voltage Programming mode. (1) debugWire is disabled. 30 0 Further programming and verification of the Flash and EEPROM is disabled in High-voltage and Serial Programming mode. The Fuse bits are locked in both Serial and High-voltage Programming mode. (1) debugWire is disabled. |
|
Link URL |
| Cho đến nay ALLDATASHEET có giúp ích cho doanh nghiệp của bạn hay không? [ DONATE ] |
Alldatasheet là | Quảng cáo | Liên lạc với chúng tôi | Chính sách bảo mật | Liên kết đến bảng dữ liệu | Trao đổi link | Tìm kiếm theo nhà sản xuất All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |