ATmega32U2 datasheet(255/314 Pages) ATMEL

tên linh kiện	ATmega32U2

Giải thích chi tiết về linh kiện	8-bit Microcontroller with 8/16/32K Bytes of ISP Flash and USB Controller

PDF	314 Pages

Scroll/Zoom	100%

nhà sản xuất	ATMEL [ATMEL Corporation]

Trang chủ	http://www.atmel.com

Logo

255 / 314 page

255

7799B–AVR–07/09

ATmega8U2/16U2/32U2

Figure 25-3. Programming the Flash Waveforms

(1)

Note:

1. “XX” is don’t care. The letters refer to the programming description above.

25.7.5

Programming the EEPROM

The EEPROM is organized in pages, see Table 25-8 on page 249. When programming the

EEPROM, the program data is latched into a page buffer. This allows one page of data to be

programmed simultaneously. The programming algorithm for the EEPROM data memory is as

follows (refer to “Programming the Flash” on page 253 for details on Command, Address and

Data loading):

A: Load Command “0001 0001”.

G: Load Address High Byte (0x00 - 0xFF).

B: Load Address Low Byte (0x00 - 0xFF).

C: Load Data (0x00 - 0xFF).

E: Latch data (give PAGEL a positive pulse).

K: Repeat 3 through 5 until the entire buffer is filled.

L: Program EEPROM page

Set BS2, BS1 to “00”.

Give WR a negative pulse. This starts programming of the EEPROM page. RDY/BSY

goes low.

Wait until to RDY/BSY goes high before programming the next page (See Figure 25-4

for signal waveforms).

RDY/BSY

RESET +12V

PAGEL

BS2

0x10

ADDR. LOW

ADDR. HIGH

DATA

DATA LOW

DATA HIGH

ADDR. LOW

DATA LOW

DATA HIGH

XA1

XA0

BS1

XTAL1

ADDR. EXT.H

ATmega32U2 bảng dữ liệu(PDF) 255 Page - ATMEL Corporation

ATmega32U2 bảng dữ liệu(HTML) 255 Page - ATMEL Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

bảng dữ liệu tải về

Link URL