| công cụ tìm kiếm bảng dữ liệu linh kiện điện tử |
|
H8S/20203 bảng dữ liệu(PDF) 222 Page - Renesas Technology Corp |
|
|
|||||||||||||||||||||||||||||
H8S/20203 bảng dữ liệu(HTML) 222 Page - Renesas Technology Corp |
|
222 / 992 page ![]() Section 7 ROM Rev. 1.00 Oct. 03, 2008 Page 196 of 962 REJ09B0465-0100 • Error code H'51 (1 byte): Erasure error indicating that erasure was unsuccessful because of an error. (6) Command Errors Command errors are caused by undefined commands, incorrect command sequence, and unacceptable commands. For example, sending a clock-mode selection command before a device selection command and sending an inquiry command after a transition-to-programming/erasure- state command both cause command errors. Error response H'80 H'xx • Error response H'80 (1 byte): Command error • Command H'xx (1 byte): Received command (7) Order of Commands In the inquiry/selection state, commands should be sent in the following order. 1. Send the supported-device inquiry command (H'20) to get the list of supported devices. 2. Select a device according to the returned device information, and send the device selection command (H'10). 3. Send the clock-mode inquiry command (H'21) to inquire about clock modes. 4. Select a clock mode from among the returned clock modes, and send the clock-mode selection command (H'11). 5. After selection of the device and clock mode, send the frequency-division-ratio inquiry command (H'22) and operating-frequency inquiry command (H'23) to get the information necessary for selecting a new bit rate. 6. Select a new bit rate according to the returned information on the frequency division ratios and operating frequencies, send the new bit-rate selection command (H'3F). 7. After selection of the new bit rate, send the user-ROM-area-information inquiry command (H'25), erasure-block-information inquiry command (H'26), and programming-size inquiry command (H'27) to get the information necessary for programming/erasing the user ROM area. 8. After each inquiry of step [7], send the transition-to-programming/erasure-state command (H'40) to cause a transition to the programming/erasure state. |
|
Link URL |
| Cho đến nay ALLDATASHEET có giúp ích cho doanh nghiệp của bạn hay không? [ DONATE ] |
Alldatasheet là | Quảng cáo | Liên lạc với chúng tôi | Chính sách bảo mật | Liên kết đến bảng dữ liệu | Trao đổi link | Tìm kiếm theo nhà sản xuất All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |