| công cụ tìm kiếm bảng dữ liệu linh kiện điện tử |
|
H8S/20203 bảng dữ liệu(PDF) 440 Page - Renesas Technology Corp |
|
|
|||||||||||||||||||||||||||||
H8S/20203 bảng dữ liệu(HTML) 440 Page - Renesas Technology Corp |
|
440 / 992 page ![]() Section 13 Timer RA Rev. 1.00 Oct. 03, 2008 Page 414 of 962 REJ09B0465-0100 13.4 Usage Notes 1. The prescaler and timer are read out per byte inside the microcomputer even when they are read out in 16-byte unit. Therefore, the timer value can be updated while those two registers are read out. 2. The TEDGF and TUNDF bits in TRACR used in pulse width and pulse cycle measurement modes assume the value 0 when 0 is written by a program and do not change if 1 is written. If one flag is set to 0 by a program, use the MOV instruction to write 1 to the other flag. In this manner, unintended flag changes can be prevented. 3. When a transition is made to pulse width or pulse cycle measurement mode from another mode, the TEDGF and TUNDF bits are undefined. Timer RA counting should be started by writing 0 to the TEDGF and TUNDF bits. 4. In some cases, the TEDGF bit becomes 1 on the first timer RA prescaler underflow signal that is generated after the start of counting. 5. When using the pulse cycle measurement mode, set the TEDGF bit to 0 by allowing a length of time 2 cycles or greater of the timer RA prescaler after the counting process is started. 6. After 1 is written to the TSTART bit when counting is stopped, the TCSTF bit remains 0 for the number of cycle of count source. Registers associated with the timer RA except the TRACR for reading should not be accessed until the TCSTF bit becomes 1. Counting starts from a valid edge of the first count source after the TCSTF bit becomes 1. After 0 is written to the TSTART bit when counting is in progress, the TCSTF bit remains 1 for the number of cycle of count source. Registers associated with the timer RA except the TRACR for reading should not be accessed until the TCSTF bit becomes 0. Counting stops when the TCSTF bit becomes 0. 7. When writing successively to TRAPRE during counting (TCSTF=1), allow a minimum write interval of 4 cycles of count source. 8. When writing successively to TRATR during counting (TCSTF=1), allow a minimum write interval of 4 cycles of count source underflow. |
|
Link URL |
| Cho đến nay ALLDATASHEET có giúp ích cho doanh nghiệp của bạn hay không? [ DONATE ] |
Alldatasheet là | Quảng cáo | Liên lạc với chúng tôi | Chính sách bảo mật | Liên kết đến bảng dữ liệu | Trao đổi link | Tìm kiếm theo nhà sản xuất All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |