| công cụ tìm kiếm bảng dữ liệu linh kiện điện tử |
|
H8S/2456R bảng dữ liệu(PDF) 485 Page - Renesas Technology Corp |
|
|
|||||||||||||||||||||||||||||
H8S/2456R bảng dữ liệu(HTML) 485 Page - Renesas Technology Corp |
|
485 / 1376 page ![]() Section 8 EXDMA Controller (EXDMAC) Rev. 1.00 Sep. 19, 2008 Page 455 of 1342 REJ09B0467-0100 (4) Transfer Abort by NMI Interrupt DMA transfer is aborted when an NMI interrupt is generated. The EDA bit is cleared to 0 in all channels. In external request mode, DMA transfer is performed for all transfer requests for which EDRAK has been output. In dual address mode, processing is executed for the write cycle following the read cycle. In block transfer mode, operation is aborted even in the middle of a block-size transfer. As the transfer is halted midway through a block, the BEF bit in EDMDR is set to 1 to indicate that the block transfer was not carried out normally. When transfer is aborted, register values are retained, and as the address registers indicate the next transfer addresses, transfer can be resumed by setting the EDA bit to 1 in EDMDR. If the BEF bit is 1 in EDMDR, transfer can be resumed from midway through a block. (5) Hardware Standby Mode and Reset Input The EXDMAC is initialized in hardware standby mode and by a reset. DMA transfer is not guaranteed in these cases. 8.4.13 Relationship between EXDMAC and Other Bus Masters The read and write operations in a DMA transfer cycle are indivisible, and a refresh cycle, external bus release cycle, or internal bus master (CPU, DTC, or DMAC) external space access cycle never occurs between the two. When read and write cycles occur consecutively, as in burst transfer or block transfer, a refresh or external bus release state may be inserted after the write cycle. As the internal bus masters are of lower priority than the EXDMAC, external space accesses by internal bus masters are not executed until the EXDMAC releases the bus. The EXDMAC releases the bus in the following cases: 1. When DMA transfer is performed in cycle steal mode 2. When switching to a different channel 3. When transfer ends in burst transfer mode 4. When transfer of one block ends in block transfer mode 5. When burst transfer or block transfer is performed with the BGUP bit in EDMDR set to 1 (however, the bus is not released between read and write cycles) |
|
Link URL |
| Cho đến nay ALLDATASHEET có giúp ích cho doanh nghiệp của bạn hay không? [ DONATE ] |
Alldatasheet là | Quảng cáo | Liên lạc với chúng tôi | Chính sách bảo mật | Liên kết đến bảng dữ liệu | Trao đổi link | Tìm kiếm theo nhà sản xuất All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |