| công cụ tìm kiếm bảng dữ liệu linh kiện điện tử |
|
H8S/2462 bảng dữ liệu(PDF) 198 Page - Renesas Technology Corp |
|
|
|||||||||||||||||||||||||||||
H8S/2462 bảng dữ liệu(HTML) 198 Page - Renesas Technology Corp |
|
198 / 1250 page ![]() Section 6 Bus Controller (BSC) Rev. 2.00 Aug. 20, 2008 Page 150 of 1198 REJ09B0403-0200 6.5.6 Wait Control When accessing the external address space, this LSI can extend the bus cycle by inserting one or more wait states (T W). There are three ways of inserting wait states: Program wait insertion, pin wait insertion using the WAIT pin, and the combination of program wait and the WAIT pin. (1) In Normal Extended Mode (a) Program Wait Mode A specified number of wait states T W are always inserted between the T2 state and T3 state when accessing the external address space. The number of wait states T W is specified by the settings of the WC1 and WC0 bits in WSCR (the WC11 and WC10 bits in WSCR2 for the 256-Kbyte extended area). (b) Pin Wait Mode A specified number of wait states T W are always inserted between the T2 state and T3 state when accessing the external address space. The number of wait states T W is specified by the settings of the WC1 and WC0 bits. If the WAIT pin is low at the falling edge of φ in the last T 2 or TW state, another T W state is inserted. If the WAIT pin is held low, TW states are inserted until it goes high. Pin wait mode is useful when inserting four or more T W states, or when changing the number of TW states to be inserted for each external device. (c) Pin Auto-Wait Mode A specified number of wait states T W are inserted between the T2 state and T3 state when accessing the external address space if the WAIT pin is low at the falling edge of φ in the last T 2 state. The number of wait states T W is specified by the settings of the WC1 and WC0 bits. Even if the WAIT pin is held low, T W states are inserted only up to the specified number of states. Pin auto-wait mode enables the low-speed memory interface only by inputting the chip select signal to the WAIT pin. Figure 6.28 shows an example of wait state insertion timing in pin wait mode. The settings after a reset are: 3-state access, 3 program wait insertion, and WAIT pin input disabled. |
|
Link URL |
| Cho đến nay ALLDATASHEET có giúp ích cho doanh nghiệp của bạn hay không? [ DONATE ] |
Alldatasheet là | Quảng cáo | Liên lạc với chúng tôi | Chính sách bảo mật | Liên kết đến bảng dữ liệu | Trao đổi link | Tìm kiếm theo nhà sản xuất All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |