| công cụ tìm kiếm bảng dữ liệu linh kiện điện tử |
|
H8S/2426R bảng dữ liệu(PDF) 326 Page - Renesas Technology Corp |
|
|
|||||||||||||||||||||||||||||
H8S/2426R bảng dữ liệu(HTML) 326 Page - Renesas Technology Corp |
|
326 / 1302 page ![]() Section 6 Bus Controller (BSC) Rev. 1.00 Sep. 19, 2008 Page 298 of 1270 REJ09B0466-0100 6.12 Bus Release This LSI can release the external bus in response to a bus request from an external device. In the external bus released state, internal bus masters except the EXDMAC* continue to operate as long as there is no external access. If any of the following requests are issued in the external bus released state, the BREQO signal can be driven low to output a bus request externally. • When an internal bus master wants to perform an external access • When a refresh request is generated • When a SLEEP instruction is executed to place the chip in software standby mode or all- module-clocks-stopped mode Note: * Not supported by the H8S/2424 Group. 6.12.1 Operation In externally expanded mode, the bus can be released to an external device by setting the BRLE bit to 1 in BCR. Driving the BREQ pin low issues an external bus request to this LSI. When the BREQ pin is sampled, at the prescribed timing the BACK pin is driven low, and the address bus, data bus, and bus control signals are placed in the high-impedance state, establishing the external bus released state. In the external bus released state, internal bus masters except the EXDMAC can perform accesses using the internal bus. When an internal bus master wants to make an external access, it temporarily defers initiation of the bus cycle, and waits for the bus request from the external bus master to be canceled. If a refresh request is generated in the external bus released state, or if a SLEEP instruction is executed to place the chip in software standby mode or all-module-clocks- stopped mode, refresh control and software standby or all-module-clocks-stopped control is deferred until the bus request from the external bus master is canceled. If the BREQOE bit is set to 1 in BCR, the BREQO pin can be driven low when any of the following requests are issued, to request cancellation of the bus request externally. • When an internal bus master wants to perform an external access • When a refresh request is generated • When a SLEEP instruction is executed to place the chip in software standby mode or all- module-clocks-stopped mode |
|
Link URL |
| Cho đến nay ALLDATASHEET có giúp ích cho doanh nghiệp của bạn hay không? [ DONATE ] |
Alldatasheet là | Quảng cáo | Liên lạc với chúng tôi | Chính sách bảo mật | Liên kết đến bảng dữ liệu | Trao đổi link | Tìm kiếm theo nhà sản xuất All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |