| công cụ tìm kiếm bảng dữ liệu linh kiện điện tử |
|
H8S/2426R bảng dữ liệu(PDF) 1126 Page - Renesas Technology Corp |
|
|
|||||||||||||||||||||||||||||
H8S/2426R bảng dữ liệu(HTML) 1126 Page - Renesas Technology Corp |
|
1126 / 1302 page ![]() Section 23 Clock Pulse Generator Rev. 1.00 Sep. 19, 2008 Page 1098 of 1270 REJ09B0466-0100 23.3 System-Clock PLL Circuit and Divider The system-clock PLL circuit and divider have the function of multiplying the frequency of the clock from the oscillator by a factor of 1, 2, or dividing by 2. The system clock frequency is set with the STC1 and STC0 bits in PLLCR. The phase of the rising edge of the internal clock is controlled so as to match that of the rising edge of the EXTAL pin. When the frequency is changed with the system-clock PLL circuit and divider, operation varies according to the setting of the STCS bit in SCKCR. When STCS = 0, the setting of the changed frequency becomes valid after a transition to software standby mode. The transition time count is performed in accordance with the setting of bits STS3 to STS0 in SBYCR. For details on SBYCR, see section 24.1.1, Standby Control Register (SBYCR). 1. The initial PLL circuit multiplication factor is 1. 2. A value is set in bits STS3 to STS0 to give the specified transition time. 3. The target value is set in bits STC1 and STC0, and a transition is made to software standby mode. 4. The clock pulse generator stops and the value set in STC1 and STC0 becomes valid. 5. Software standby mode is cleared, and a transition time is secured in accordance with the setting in STS3 to STS0. 6. After the set transition time has elapsed, this LSI resumes operation using the target multiplication factor. When STCS = 1, a change to the frequency setting becomes effective a maximum of four cycles after the setting is changed. If the clock frequency is changed during access to an external address space, correct operation cannot be guaranteed. Therefore, be sure to store instructions that change the STC1 and STC0 bits and other instructions to be executed within a maximum of four cycles after the change to the frequency setting in on-chip ROM or on-chip RAM, so that instructions do not access an external address space before the frequency clock is switched over. |
|
Link URL |
| Cho đến nay ALLDATASHEET có giúp ích cho doanh nghiệp của bạn hay không? [ DONATE ] |
Alldatasheet là | Quảng cáo | Liên lạc với chúng tôi | Chính sách bảo mật | Liên kết đến bảng dữ liệu | Trao đổi link | Tìm kiếm theo nhà sản xuất All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |