| công cụ tìm kiếm bảng dữ liệu linh kiện điện tử |
|
H8S/2112 bảng dữ liệu(PDF) 443 Page - Renesas Technology Corp |
|
|
|||||||||||||||||||||||||||||
H8S/2112 bảng dữ liệu(HTML) 443 Page - Renesas Technology Corp |
|
443 / 894 page ![]() Section 14 Serial Communication Interface (SCI) Rev. 1.00 Mar. 18, 2008 Page 419 of 866 REJ09B0451-0100 14.7.8 Clock Output Control Clock output can be fixed using the CKE1 and CKE0 bits in SCR when the GM bit in SMR is set to 1. Specifically, the minimum width of a clock pulse can be specified. Figure 14.31 shows an example of clock output fixing timing when the CKE0 bit is controlled with GM = 1 and CKE1 = 0. Specified pulse width SCK CKE0 Specified pulse width Figure 14.31 Clock Output Fixing Timing At power-on and transitions to/from software standby mode, use the following procedure to secure the appropriate clock duty ratio. (1) At Power-On To secure the appropriate clock duty ratio simultaneously with power-on, use the following procedure. 1. Initially, port input is enabled in the high-impedance state. To fix the potential level, use a pull-up or pull-down resistor. 2. Fix the SCK pin to the specified output using the CKE1 bit in SCR. 3. Set SMR and SCMR to enable smart card interface mode. 4. Set the CKE0 bit in SCR to 1 to start clock output. |
|
Link URL |
| Cho đến nay ALLDATASHEET có giúp ích cho doanh nghiệp của bạn hay không? [ DONATE ] |
Alldatasheet là | Quảng cáo | Liên lạc với chúng tôi | Chính sách bảo mật | Liên kết đến bảng dữ liệu | Trao đổi link | Tìm kiếm theo nhà sản xuất All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |