IS25LE512MG-RHLA2:PTY datasheet(166/194 Pages) ISSI

tên linh kiện	IS25LE512MG-RHLA2:PTY

Giải thích chi tiết về linh kiện	SERIAL FLASH MEMORY 166/133MHZ MULTI I/O SPI & QUAD I/O QPI DTR INTERFACE WITH ON-CHIP ECC

PDF	194 Pages

Scroll/Zoom	100%

nhà sản xuất	ISSI [Integrated Silicon Solution, Inc]

Trang chủ	http://www.issi.com

Logo

166 / 194 page

IS25LE512MG

IS25WE512MG

Integrated Silicon Solution, Inc.- www.issi.com

166

Rev. A6

10/02/2025

8.64 GANG SECTOR/BLOCK LOCK OPERATION (GBLK, 7Eh)

The Gang Sector/Block Lock (GBLK) instruction provides a quick method to set all DYB (Dynamic Protection Bit)

bits to “0” at once.

Before the GBLK (7Eh) command can be accepted by the device, a Write Enable (WREN) command must be

issued and decoded by the device, which sets the Write Enable Latch (WEL) in the Status Register to enable any

write operations.

The sequence of issuing GBLK instruction is: drive CE# low → send GBLK instruction code → drive CE# high.

The instruction code will be shifted into the device on the rising edge of SCK.

The GBLK command is accepted in both SPI and QPI mode. The CE# must go high exactly at the byte boundary,

otherwise, the instruction will be ignored. While the GBLK operation is in progress, the Status Register or Extended

Read Register may be read to check the value of the Write In Progress (WIP) bit. The WIP bit is “1” during the

GBLK operation, and is “0” when it is completed.

It takes 70us (typ) to complete GBLK operation.

Figure 8.143 Gang Sector/Block Lock Sequence In SPI Mode

Instruction = 7Eh

CE#

SCK

Mode 3

Mode 0

High Impedance

Figure 8.144 Gang Sector/Block Lock Sequence In QPI Mode

7Eh

CE#

SCK

IO[3:0]

Mode 3

Mode 0

IS25LE512MG-RHLA2:PTY bảng dữ liệu(PDF) 166 Page - Integrated Silicon Solution, Inc