STM32F732IE datasheet(143/226 Pages) STMICROELECTRONICS

143 / 226 page

DS11854 Rev 6

143/226

STM32F732xx STM32F733xx

Electrical characteristics

198

Designing hardened software to avoid noise problems

EMC characterization and optimization are performed at component level with a typical

application environment and simplified MCU software. It should be noted that good EMC

performance is highly dependent on the user application and the software in particular.

Therefore it is recommended that the user applies EMC software optimization and

prequalification tests in relation with the EMC level requested for his application.

Software recommendations

The software flowchart must include the management of runaway conditions such as:

•

Corrupted program counter

•

Unexpected reset

•

Critical Data corruption (control registers...)

Prequalification trials

Most of the common failures (unexpected reset and program counter corruption) can be

reproduced by manually forcing a low state on the NRST pin or the Oscillator pins for 1

second.

To complete these trials, ESD stress can be applied directly on the device, over the range of

specification values. When unexpected behavior is detected, the software can be hardened

to prevent unrecoverable errors occurring (see application note AN1015).

Electromagnetic Interference (EMI)

The electromagnetic field emitted by the device are monitored while a simple application,

executing EEMBC code, is running. This emission test is compliant with SAE IEC61967-2

standard which specifies the test board and the pin loading.

6.3.18

Absolute maximum ratings (electrical sensitivity)

Based on three different tests (ESD, LU) using specific measurement methods, the device is

stressed in order to determine its performance in terms of electrical sensitivity.

Electrostatic discharge (ESD)

Electrostatic discharges (a positive then a negative pulse separated by 1 second) are

applied to the pins of each sample according to each pin combination. The sample size

Table 57. EMI characteristics

Symbol Parameter

Conditions

Monitored

frequency band

Max vs.

[fHSE/fCPU] Unit

25/200 MHz

SEMI

Peak level

VDD = 3.6 V, TA = 25 °C, conforming to

IEC61967-2 ART/L1-cache OFF, over-drive ON,

all peripheral clocks enabled, clock dithering

disabled.

0.1 MHz to 30 MHz

dBµV

30 MHz to 130 MHz

130 MHz to 1 GHz

1 GHz to 2 GHz

EMI Level

STM32F732IE bảng dữ liệu(PDF) 143 Page - STMicroelectronics

STM32F732IE bảng dữ liệu(HTML) 143 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

bảng dữ liệu tải về

Link URL