| công cụ tìm kiếm bảng dữ liệu linh kiện điện tử |
|
STR720 bảng dữ liệu(PDF) 153 Page - STMicroelectronics |
|
|
|||||||||||||||||||||||||||||
STR720 bảng dữ liệu(HTML) 153 Page - STMicroelectronics |
|
153 / 401 page ![]() STR720 - REAL TIME CLOCK (RTC) 153/401 RTCCR: RTC Control Register Address Offset: 00h Reset value: 0020h The functions of the RTC are controlled by this control register. It is not possible to write this register while the peripheral is completing a previous write operation (flagged by RTOFF=0 (see “Configuration mode” on page 152). Bit 15:11 = Reserved. These bits must always be written to ‘0’. Bit 10 = PEREN: PERiodic interrupt ENable 0: Periodic interrupt is masked. 1: Periodic interrupt is enabled. Bit 9 = AEN: Alarm interrupt ENable 0: Alarm interrupt is masked. 1: Alarm interrupt is enabled. Bit 8 = Reserved. This bits must always be written to ‘0’. The above listed bits are used to mask interrupt requests. Note that at reset all interrupts are disabled, so it is possible to write the RTC registers so that no interrupt requests are pending after initialization. Bits 7:6 = Reserved. These bits must always be written to ‘0’. Bit 5 = RTOFF: RTc operation OFF With this bit RTC reports the status of the last write operation performed on its registers, indicating if it has been completed or not. If its value is ‘0’ then it is not possible to write any RTC register. This bit can only be read by software. 0: Last write operation on RTC registers is still active. 1: Last write operation on RTC registers terminated. Note A read operation on RTC registers with RTOFF=0 returns anyway their current value. Bit 4 = CNF: CoNfiguration Flag This bit must be set at ‘1’ by software in order to enter the configuration mode thus allowing to write new values in RTCCNT, RTCA, RTCP registers. The writing operation is really executed when the CNF bit after being set, is reset again by software. 0: Exit configuration mode (start update of RTC registers). 1: Enter configuration mode. Bit 3 = Reserved. This bits must always be written to ‘0’, but it will be read back as ‘1’. 15 14 13 12 11 10 9 8 765432 1 0 Reserved PEREN AEN Res. Reserved RTOFF CNF Res. PERIR AIR Res. -rw rw - - r rw - rc rc - 1 |
|
Link URL |
| Cho đến nay ALLDATASHEET có giúp ích cho doanh nghiệp của bạn hay không? [ DONATE ] |
Alldatasheet là | Quảng cáo | Liên lạc với chúng tôi | Chính sách bảo mật | Liên kết đến bảng dữ liệu | Trao đổi link | Tìm kiếm theo nhà sản xuất All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |